Commissioning; Putting The Unit Into Operation; Automatic Mode; Manual Operation - Dentsply Sirona inLab MC X5 230 V Operating Instructions Manual

5 Commissioning

5.1 Putting the unit into operation

18
5
Commissioning
Putting the unit into operation
5.1
5.1.1

Automatic mode

ü The interface cable is connected.
➢ Set the on/off switch to the position Auto.
Note on the automatic mode:
The production unit monitors the correct connection (interface cable and
suction tube) and the operation of the suction system during the running
processes.
5.1.2

Manual operation

NOTE
Manual mode only permitted for inLab MC X5. For CEREC MC/MC X/
MC XL Premium Package/Primemill only automatic mode is
supported.
1. Prior to commencing processing, set the on/off switch to the On
position.
2. Once processing has been completed, set the on/off switch to the
Off position.
5.1.3

Setting the suction power

inLab MC X5
➢ Set the suction power to the maximum (max).
CEREC MC/MC X/MC XL Premium Package/Primemill
➢ Set the suction power to the minimum (min). If required, the suction
power can be set to the maximum.

Repacking

5.2
1. Set the on/off switch to the position Off.
2. Remove the power plug, interface cable, and suction tube.
3. Check the suction device for completeness according to the scope
of supply.
4. Pack the device safely, ideally in the original transport packaging.
Dentsply Sirona
Operating Instructions for suction devices
66 25 540 D3608
D3608.201.02.05.02 10.2020