Snmp Master Option; Last Snmp Master Option; Last Snmp Poll Option; Snmp Trap Ip Option - TANDBERG evolution 5000 E5710 Instruction Manual

Operating the Equipment Locally
Gateway Address
¬ Left
® Right
O
O

SNMP Master Option

To access the SNMP Master option, press the SNMP Master softkey in the
Remote Control Menu. This gives the SNMP Master's IP address. If this is
set, only one SNMP controller will be allowed access to the Encoder. It can
be set to 000.000.000.000 to allow any controller access.
SNMP Master
¬ Left
® Right
O
O

Last SNMP Master Option

The Last SNMP Master option is found in the Remote Control Menu. This
gives the last SNMP Master's IP address. It cannot be changed.

Last SNMP Poll Option

The Last SNMP Poll option is found in the Remote Control Menu. It cannot
be changed

SNMP Trap IP Option

To access the SNMP Trap IP option, press the SNMP Trap IP softkey in
the Remote Control Menu.
If this option is set, trap messages will be sent to the specified IP address.
If this is 000.000.000.000 then trap messages will be sent to the last
SNMP master.
SNMP Trap IP
¬ Left
® Right
O
O

SABus Address Option

To access the SABus Address option, press the SABus Address softkey in
the Remote Control Menu. The SABus protocol is multi-drop, and has an
address byte for differentiating between the devices on the SABus (the
address option).
Page 4-22
Gateway Address :
`000.000.000.000'
Update using softkeys
SNMP Master IP Address :
`000.000.000.000'
Update using softkeys
Send SNMP Traps to IP Address :
`000.000.000.000'
Update using softkeys
Enter l
Quit l
Enter l
Quit l
Enter l
Quit l
Instruction Manual: evolution 5000 E5710 and E5720 Encoder
+
—
+
—
+
—
ST.TM.E10074.1