Remote Control Menu; Overview; Ip Address Option; Mac Address Option - TANDBERG evolution 5000 E5710 Instruction Manual

PMT PID
¬ Left
® Right
l Ins
l Del
4.7.4

Remote Control Menu

Overview

The Remote Control Menu is selected from the System Menu by pressing
the Remote Control softkey. This menu provides options for amending
the remote control options. See Figure 4.9 for the Remote Control Menu
structure.

IP Address Option

To access the IP Address option, press the IP Address softkey in the
Remote Control Menu. The Encoder must be reset if the IP address is
changed.
IP Address
¬ Left
® Right
O
O

MAC Address Option

The MAC Address option is found in the Remote Control Menu. It cannot
be changed.

Network Mask Option

To access the Network Mask option, press the Network Mask softkey in
the Remote Control Menu.
Network Mask
¬ Left
® Right
O
O

Gateway Address Option

To access the Gateway Address option, press the Gateway Address
softkey in the Remote Control Menu. This gives the default gateway
address used on the Ethernet network interface connected via the 10BaseT
socket. Any communications to network hosts not on the local IP network
will be sent to this address.
Instruction Manual: evolution 5000 E5710 and E5720 Encoder
ST.TM.E10074.1
Logical Channel :
`3 (0003h)'
Update using softkeys
Encoder IP Address :
`172.16.248.91'
Update using softkeys
Network Mask :
`255.255.0.0'
Update using softkeys
Operating the Equipment Locally
+
—
Enter l
Quit l
+
—
Enter l
Quit l
+
—
Enter l
Quit l
Page 4-21