B.10.3 M2/Eom2/Remux Remux Option Module; Connectors; Leds - TANDBERG evolution 5000 E5710 Instruction Manual

Technical Specification

B.10.3 M2/EOM2/REMUX Remux Option Module

Connectors

NOTE...
The M2/EOM2/REMUX Remux Option Module is supported by Encoder software version 2.2 and later.
Table B.23: DVB ASI In 1, 2 and 3 Connector
Item
Safety status
Connector designation
Connector type
Connector impedance
Data coding
Channel rate
Specification
Table B.24: DVB ASI Out 1 Connector (Disabled)
Item
Safety status
Connector designation
Connector type
Connector impedance
Data coding
Channel rate
Specification

LEDs

Table B.25: DVB ASI In 1, 2 and 3 - LED Indications
Item
Red LED
On
Off
Green LED
Off
Flash (1:3 mark:space)
Flash (3:1 mark:space)
4
75 W terminator must be fitted when this interface is not in use.
5
Byte mode and single packet burst mode only.
6
75 W terminator must be fitted when this interface is not in use.
7
Byte mode and single packet burst mode only.
Page B-16
Specification
SELV
DVB ASI IN 1, DVB ASI IN 2, DVB ASI IN 3
BNC
75 W 4
8B/10B
270 Mbit/s
DVB A010 rev 1 (Asynchronous Serial Interface)
Specification
SELV
DVB ASI OUT 1
BNC
75 W
6
8B/10B
270 Mbit/s
DVB A010 rev 1 (Asynchronous Serial Interface)
Specification
Input ASI lock
No lock on ASI (8B/10B coding)
Input ASI lock OK
Packet size
Not locked to MPEG packets
188 byte packets
204 byte packets
Instruction Manual: evolution 5000 E5710 and E5720 Encoder
5
7
ST.TM.E10074.1