Table of Contents
Advertisement
COMP VIDEO
A 75 W BNC connector provides a high quality
analogue video input to the unit. See Chapter 4,
Operating the Equipment Locally, Video Input Option
on page 4-30 for the types of video and selection
method.
NOTE...
The input is differential to prevent 50 Hz/60 Hz hum.
Table 2.4: COMP VIDEO Connector
Pin
Centre
Screen
Impedance
2.5.6
Audio Inputs
Connect the audio cable to the AUDIO IN
connector. The 15-way, D-type male connector is
used in different ways according to the audio input
and the encoding configuration selected.
The connector provides two stereo pairs. They may be independently
configured as either analogue or digital. The left channel is used to input
digital audio.
The Encoder is supplied with a break-out cable which plugs into this
connector, and provides a more convenient means of connecting the audio
signals via five connectors. There are four XLR female connectors, with the
fifth cable being a BNC which provides an AES/EBU 75 W digital reference
output.
Table 2.5: Audio In Connector
Pin
Analogue
1
Left Channel A (+)
2
Not connected
3
Right Channel A (-)
4
Left Channel B (+)
5
Not connected
6
Right Channel B (-)
7
8
Not connected
Instruction Manual: evolution 5000 E5710 and E5720 Encoder
ST.TM.E10074.1
Signal
Video Input
Video Input Return
75 W
Signal
Digital
AES/EBU (A) (+)
AES/EBU (B) (+)
AES/EBU
Reference (Signal)
Pin
Signal
Analogue
9
Left Channel A (-)
10
Right Channel A (+)
11
Not connected
12
Left Channel B (-)
13
Right Channel B (+)
14
Not connected
15
Installing the Equipment
Digital
AES/EBU (A) (-)
AES/EBU (B) (-)
AES/EBU
Reference (Ground)
Page 2-11
Advertisement
Chapters
Table of Contents
