Table of Contents
Advertisement
Installing the Equipment
NOTES...
In analogue mode termination is either 20 kW or 600 W.
1.
2.
In AES/EBU mode termination is 110 W.
3.
When the Encoder is powered down the digital channel is selected with 110 W termination.
4.
The digital audio input does not support SPDIF.
5.
In order to comply with EMC regulations, use the audio break-out cable supplied with the unit.
2.5.7
ASI OUT 1, 2 and 3 Outputs
Connect the Multiplexer or Modulator ASI cable to the
appropriate ASI OUT connector, using good quality
75 W coaxial cable (for example, BBC PSF 1/3).
A 75 W BNC connector provides the output from the Encoder.
Table 2.6: ASI OUT 1, 2 and 3 Connectors
Pin
Centre
Screen
2.5.8
Control Interfaces
Connection
Operation of the Encoder from a TANDBERG Television control system is
via the Ethernet network running the Simple Network Management
Protocol (SNMP) protocol. Connect the ETHERNET connector to the
controller (for example, MEM). Local control is implemented through the
front panel keypad and display. See Chapter 4, Operating the Equipment
Locally for details of how to access the front panel menus.
Ethernet #1 and #2
An 8-way, RJ-45 connector provides a 10BaseT
Ethernet interface for communications with the MEM
for control and monitoring. The Encoder has a single
switched Ethernet channel. Ethernet#1 is selected as
default at power-up. If a carrier is not detected on
Ethernet#1 then the input switches to Ethernet#2.
This gives a redundant Ethernet control via two hubs.
Table 2.7: Ethernet Connector
Pin
1
2
3
Page 2-12
Signal
Signal
Ground
Signal
Pin
Tx Out (+)
4-5
Tx Out (-)
6
Rx In (+)
7-8
Signal
Not connected
Rx In (-)
Not connected
Instruction Manual: evolution 5000 E5710 and E5720 Encoder
ST.TM.E10074.1
Advertisement
Chapters
Table of Contents
