Analogue Video Specification; Encoder Settings For Pal/Ntsc Video Performance Figures; Pal Video Performance Figures - TANDBERG evolution 5000 E5710 Instruction Manual

Technical Specification

Analogue Video Specification

Table B.3: Analogue Video Specification
Item
Analogue input
Connector designation
Connector type
Input level
Return loss
Input impedance
NOTE...
The inputs are isolated from the chassis to prevent 50 Hz/60 Hz hum.

Encoder Settings for PAL/NTSC Video Performance Figures

The Encoder settings for the PAL/NTSC video performance figures are
shown in Table B.4.
NOTE...
The PAL and NTSC video performance figures are measured when the Encoder is connected to an
Alteia
plus
Table B.4: Encoder Settings for PAL/NTSC Video Performance Figures
Item
Noise reduction
Video bit-rate
Resolution
GOP
Profile
Packet length
Mux Bit-rate

PAL Video Performance Figures

Table B.5: PAL System Video Performance Figures
Pattern
VITS Line 17
VITS Line 17
VITS Line 17
VITS Line 17
Page B-4
Specification
625 line composite PAL-B, -D, -G, -H, -I
525 line composite NTSC-M, PAL-M as specified in ITU-R report 624-4, Characteristics of
Television Systems (NTSC with and without set-up of 7.5 IRE)
COMP VIDEO
75 W BNC socket
1 V pk-pk nominal ±5%
Better than 30 dB up to 6 MHz (when impedance is set to 75 W)
75 W/High Z switchable (powered-down impedance = 75 W)
Decoder.
Specification
Off
8 Mbit/s
720 x 576
IP
422P@ML
188
40 Mbit/s
Item
Input return loss
Bar amplitude ref (bp)
Jitter
Luminance bar tilt
2T pulse K-rating
Instruction Manual: evolution 5000 E5710 and E5720 Encoder
Specification
35 dB
700 mV ± 7 mV
5 ns pk-pk
±0.2%
±1.0% KF
ST.TM.E10074.1