Basic Interoperable Scrambling System - Biss (M2/Edcom2/Biss) - TANDBERG evolution 5000 E5710 Instruction Manual

Table 3.3: Minimum Bit-rates With and Without Performance Upgrade
Performance
Upgrade
û
û
ü
ü
NOTE...
B is the minimum bit-rate that can be set.
min
3.3 Basic Interoperable Scrambling System - BISS
(M2/EDCOM2/BISS)
With the appropriate configuration, the Encoder can use the Basic
Interoperable Scrambling System (BISS) to scramble the outgoing
transport stream. This system has been developed by the European
Broadcasting Union (EBU) as an open scrambling system.
BISS has three main levels of operation: Mode 1, Mode 2 and Mode 3.
Mode 0 corresponds to no scrambling.
NOTE...
Only Modes 0 and 1 are available at this release (Build version 2.0.0). Modes 2 and 3 are not
supported.
BISS Mode 1 operation uses a fixed value for the control word to scramble
the services in the transport stream from the Encoder. To descramble the
transmission, the Decoder needs to have the matching control word value.
The BISS Module (M2/EDCOM2/BISS) comprises Assembly S12284 and
Card S11484.
NOTES...
1. This option module is installed as a daughter card to the Base Board, with no external
connectors and does not use an option slot.
2. The BISS software must also be enabled in the Encoder (see Customer Services).
BISS scrambling (when fitted) is enabled and controlled via the Setup/Mux
Menu (see Chapter 4, Operating the Equipment Locally, Section 4.12.10).
1
1.5 Mbit/s, but possibly higher if limited by Coding Mode.
Instruction Manual: evolution 5000 E5710 and E5720 Encoder
ST.TM.E10074.1
Reflex B Non-seamless
min
Licence Modes
û
1.5 Mbit/s
ü 1.5 Mbit/s
û
0.256 Mbit/s
ü 0.256 Mbit/s
B Seamless Modes
min
(Front Panel, SNMP)
1.5 Mbit/s 1
1.5 Mbit/s
1
Depends on Coding Mode
Depends on Coding Mode
Options and Upgrades
B Seamless Modes
min
(Reflex, MEM)
Not Possible
Depends on Coding Mode
Not Possible
Depends on Coding Mode
Page 3-5