Connecting Up The Basic Encoder - TANDBERG evolution 5000 E5710 Instruction Manual

Alarm
Base Board
Option Slots 4-6
Option Slots 1-3
Figure 2.4: E5720 (2U) Rear Panel Component Parts and Connectors
2.5.2

Connecting Up the Basic Encoder

Once the unit has been installed in its intended operating position, it is
ready to be connected up to the rest of the system equipment
(see Figure 2.5), providing it too has been installed (see Signal
Connections for pin-out details of the connectors).
Serial Digital Interface
Studio Black and Burst
Analogue composite video
Audio input
AES/EBU Reference
10BaseT
10BaseT
RS-232/RS-485
RS-232 data input
RS-422 data input
Figure 2.5: Equipment Connections for the Basic Unit
Instruction Manual: evolution 5000 E5710 and E5720 Encoder
ST.TM.E10074.1
RS-232/
RS-422
RS-232
RS-485
Data
Data
Control
Option Slot 4
Option Slot 1
Video Input
SDI IN
H SYNC
COMP VIDEO
Audio Input
AUDIO IN
Control
ETHERNET #1
ETHERNET #2
REMOTE CONTROL
Data
RS-232 DATA
RS-422 DATA
ASI
Outputs
SDI In
Ethernet
Option Slot 5
Option Slot 2
Encoder
Output
ASI OUT 1
ASI OUT 2
ASI OUT 3
Alarm
ALARM
Installing the Equipment
Audio In and
Audio
Composite
Reference Out
H Sync
Video
Option Slot 6
Option Slot 3
DVB/ATSC Transport stream output
DVB/ATSC Transport stream output
DVB/ATSC Transport stream output
Alarm
Technical
Earth
Page 2-9