Operating The Equipment Locally; Introduction; Establishing Local Control (E5710); Navigating The Display Screens (E5710) - TANDBERG evolution 5000 E5710 Instruction Manual

4.1

Introduction

The front panel display and keypad may be used to configure, control and
monitor the Encoder when an evolution 5000 Multiplex Element Manager
(MEM) is not used.
4.2

Establishing Local Control (E5710)

At switch-on the Encoder runs through a boot sequence (boot time without
any option modules is approximately 45 seconds). The Summary Screen is
displayed.
Service name
Default Service
204 Bytes
188 or 204 byte transport
packet output mode
Figure 4.1: E5710 Summary Screen
4.3

Navigating the Display Screens (E5710)

4.3.1 Introduction
The menu items on the display are selected and amended by one of the
four navigation keys (shown as left, right, up and down arrows) and Enter
and Cancel buttons (see Figure 4.2). Most of the screens displayed in this
manual are for the E5720 2U Encoder and are accessed in a different way
(see Section 4.5, Navigating the Display Screens (E5720)) but the menu
options are the same for both the 1U and 2U Encoders.
The function of the navigation keys depends where you are in the menu
structure. See the following sections for details.
ENTER
button
CANCEL
button
Figure 4.2: E5710 Navigation Keys and Buttons
Instruction Manual: evolution 5000 E5710 and E5720 Encoder
ST.TM.E10074.1
Any of the following can be displayed:
Initialising
On Air
Off Air
Scrambled
40.000 Mbit/s
Output transport stream bit-rate (at
whichever packet length has been selected)

Operating the Equipment Locally

Only shown when the Encoder is booting
Outputs are on
Outputs are off
Outputs are on and transport stream being
scrambled with selected CA standard
(On Air)
Serial Digital
Video source selected
Navigation keys
Page 4-5