Table of Contents
Advertisement
Available languages
Available languages
ENGLISH
HAZARDS AND SAFETY PROVISIONS DURING ASSEMBLY
When assembling the appliance, watch out for the following hazards and provide for the counter-
measures indicated below:
► Source of hazard: Handling of heavy loads
Where or in which situations
Hazard
does the hazard occur?
Risk of injury due
to body overload
HAZARDS AND SAFETY PROVISIONS DURING INSTALLATION AND
COMMISSIONING, ADJUSTMENTS AND PART REPLACEMENT
During appliance installation, commissioning, adjustment and part replacement procedures, watch
out for the following hazards and provide for the countermeasures indicated below.
► Source of hazard: Appliance mechanics
Hazard
Risk
of
crushing
parts of the body in
case of tip-over or
fall of the appliance
Risk of cutting due
to sharp edges
Risk
of
crushing
parts of the body in
case of fall of the ap-
pliance
6
• When the appliance
moves
Where or in which situations
does the hazard occur?
When the appliance is lifted • Pay attention to the centre
When handling sheet-metal
parts
In case of uneven or sloped
floors
Countermeasures
• Use a suitable lifting device
to place the appliance on
the work bench, on the base
• Adjust the position only if a
suitable number of people
is available, otherwise ob-
serve the limit values for lift-
ing and transport
• Comply with the applicable
laws on accident prevention
for the installation place
• Wear personal protective
equipment
Countermeasures
of gravity
• Avoid collisions
• Pay special care during this
activity
• Wear personal protective
equipment in accordance
with safety regulations
• Comply with the correct in-
stallation requirements as
per section "Installing the
appliance" on page 10 of
the installation manual.
SAFETY
Safety device
• Protective
gloves
• Protective
shoes
• Safety helmet
(e.g. for sus-
pended loads,
overhead
operations...)
Safety device
None
None
None
3320040_ut_GB_rev.3
Advertisement
Chapters
Table of Contents
Troubleshooting
