Rll Components Adjustment Rules; Buckles - Belarus 1523.5 Operator's Manual

Table of Contents

1523.5-0000010 OM

4.3.3 RLL components adjustment rules

Buckles are used to limit side swaying of RLL lower links in transport and in operat-

ing position. Your tractor can be equipped with outer turnbuckles.

Buckles 2 (figure 4.3.3) are fixed with one end to eye lugs 3 of lower links 4. The other end

of buckles with hinge joints is fixed into the brackets of buckles 1 with the help of pins. The

brackets of buckles 1 are fixed on the lower part of RLL semi-axle tubes

1 – buckle bracket; 2 – buckle; 3 – eye lug; 4 – lower link.

Figure 4.3.3 – Installing of buckles in RLL

The buckle consists of screw 1 (figure 4.3.4), guiding pin 2, slide piece 4 and linch pin 3.

Guiding pin 2 has a through groove on the side surface and a through hole in the surface

perpendicular to it.

Slide piece 4 has two through holes in one plane.

а) buckle locked

b) buckle unlocked

1 – screw; 2 – guiding pin; 3 – linch pin; 4 – slide piece.

Figure 4.3.4 – Setting of buckles

While tractor operation buckles shall always be locked in one of the two positions:

buckle locked;

buckle unlocked.

Setting of buckles shall be carried out with the implement mounted on lower links rear

ends and lowered onto the supporting surface.

Setting of "buckle locked" shall be carried out in the following order:

- match the hole for linch pin 3 in guiding pin 2 with the hole in slide piece 4;

- in case of mismatch, turn guiding pin 2 clockwise or counterclockwise until the holes

match;

- insert linch pin 3 into the hole and fix it with the spring clip.

Setting of "buckle unlocked" shall be carried out in the following order:

- turn guiding pin 2 for ≈90 and match the groove in guiding pin 2 with the hole in slide

piece 4;

- while rotating guiding pin 2, place the hole in slide piece 4 on the groove center (adjust

the right and left buckles);

- insert linch pin 3 into the hole and fix it with the clip.

101

Table of Contents