Table of Contents
Advertisement
Operating Manual
MHM-97884
2. Click Next.
3. Enter the expected temperature at the sensor mounting location as exact as
4. Mount the sensor into the calibration gauge.
5. With the micrometer screw, adjust the distance between measuring object and
MHM-97884, Rev. 1.8
The sending progress is displayed.
Step 1
and
Step 2
are skipped if an already configured converter is connected and
the parameters of the dialogs Basic, Input, and Measurement are unchanged.
possible. If sensor and converter have the same temperature, use the button
the dialog to measure the internal temperature of the converter. This step is only
necessary if an EZ105x or an EZ108x sensor is connected to the AMS EZ 1000
Converter.
Figure 8-27: Dialog – sensor temperature
sensor tip to the maximum gap stated in row B of
column [mm] can not be changed here and depend on the selected sensor and the
extended range factor (see
Figure
Table
8-2).
Configuration
October 2023
in
8-28. The distances in
83
Advertisement
Table of Contents
