Table of Contents
Advertisement
Operating Manual
MHM-97884
3-wire connection
Because of the higher immunity to external influences on the sensor signal the
recommended connection type is the 4-wire connection as described in
output signal
1000 Converter can also be connected by using three wires because of the internal
interconnection of the GND terminals for power supply and output signal.
Figure 5-13
grounding concept is one possibility. Adapt the grounding concept to the on-site
requirements.
MHM-97884, Rev. 1.8
connection. If it is not possible to use the 4-wire connection, the AMS EZ
exemplifies the 3-wire connection of an AMS EZ 1000 Converter. The shown
Installation and commissioning
October 2023
Power supply and
31
Advertisement
Table of Contents
