Table of Contents
Advertisement
Operating Manual
MHM-97884
Table 3-1: LED blinking pattern
Event
Automatic calibration
with AMS Machine
Studio – failure
detected
Firmware update
Sensor error
Sensor is too close to
the measuring object
Converter error
No power supply
Factory default
Factory calibrated
1
MHM-97884, Rev. 1.8
Blinking pattern
Unlimited fast flashing (5 Hz) – until power
off/on the converter
Slow flashing (1 Hz) while waiting for button
press
Steady light while erasing and writing the
firmware
LED off
Continuously triple flashing
Slow flashing (1 Hz) for approximately 3 seconds
after power on the converter
= on /
= off
(continued)
Application and design
October 2023
1
Sequence
17
Advertisement
Table of Contents
