Table of Contents
Advertisement
Configuration
October 2023
Figure 8-7: Configuration
A. Ribbon command bar
B. Configuration dialog
C. Converter name with type of used interface in brackets
D. List of configuration pages
8.5.1
Ribbon command bar
New configuration
Click New configuration to start a new configuration with default parameters.
Figure 8-8: Button New configuration
Send & close
Click Send & close to send the configuration to the converter. The configuration editor
automatically closes after the sending process. This command requires an online
connection to the converter.
Minor changes to the configuration can be sent without recalibration of the converter.
Major changes require a recalibration. In this case, the configuration is sent by the
calibration process.
Minor changes are:
•
All parameters on the Basic tab.
•
The parameters Point Id, Serial number of the sensor, and Serial number of the cable
on tab Input.
68
Operating Manual
MHM-97884
MHM-97884, Rev. 1.8
Advertisement
Table of Contents
