Table of Contents
Advertisement
Operating Manual
MHM-97884
4. Select the converter to be configured, and click Configure.
5. Open the saved configuration file (window File, menu item Open).
6. Check the configuration – does the configuration meet the requirements of the
7. The calibration data is not always included in the saved configuration file. If the
8. If a single file is needed, save the configuration (Configuration editor → File →
9. Close AMS Machine Studio, and disconnect from the converter.
8.1.2
Online configuration overview
Procedure
1. Switch on the power supply of the converter, if not already done.
2. Connect the converter to the configuration computer by using the USB connection.
MHM-97884, Rev. 1.8
The converter is automatically detected by AMS Machine Studio.
Note
If a custom sensor file provided by Emerson has been opened, parameters that do
not need to be configured are grayed out.
measurement?
Calibration tab is marked with the yellow warning triangle, start the calibration
process, and select a calibration method (see Calibration).
Figure 8-1: Calibration required
The configuration is sent to the converter during the calibration process.
The configuration is automatically saved to the current project.
Save as).
The data of the calibration is saved with the configuration file. The data of the
Automatic calibration and the Offline calibration (Easy calibration – calibration
process without AMS Machine Studio) is saved as Manual calibration data.
Note
Before saving the configuration, reload the configuration including the calibration
data from the AMS EZ 1000 Converter. See Reload.
After these steps, the converter is ready for operation.
Configuration
October 2023
63
Advertisement
Table of Contents
