Measurement - Emerson Machinery Health AMS EZ 1000 Operating Manual

Configuration
October 2023
Serial number Enter the serial number of the used sensor. See sensor or sensor cable
Extension
cable
Serial number Enter the serial number of the used extension cable. See label of the
Note
The sensor adapters EZ1900-003-ADAP-1 and EZ1900-003-ADAP-2 are automatically
considered during the calibration process, if Sensor → PR 6424, PR 6425, PR 6426, or
3301x is selected.
The overall cable length (sensor cable plus extension cable) of the selected components
must be in whole numbers. An overall cable length of, for example, 5.5 meters cannot be
selected.
When using the EZ1900-ADAP-90 adapter to connect an EZ108x-xx-xx-xxx sensor, ensure
that the overall cable length is in the range of 4 to 10 meters.
8.5.4

Measurement

Enter the measurement details.
Note
The change of the measurement details of an already configured converter requires the
recalibration of the converter.
Figure 8-21: Measurement
Extended
range
factor
74
for the serial number.
If an extension cable is used, click the button
to open the selection dialog for the extension cable. The dialog lists all
extension cables compatible with the AMS EZ 1000 Converter and the
sensor already selected. Select the appropriate extension cable or select
No extension cable, and click OK.
extension cable for the serial number.
The standard measuring range of several eddy current sensors can be
extended. Use this list field to select a factor for the range extension. The
available factors depend on the selected sensor (see Input → Sensor). The
standard measuring range is multiplied with the selected factor. Example
with EZ108x-xx-xx-xxx with standard range of 2.0 mm (absolute) and
selected factor of 2.0:
Extended range = Standard Range * Factor
Extended range = 2.0 mm * 2.0 = 4.0 mm
Operating Manual
MHM-97884
behind the display field
MHM-97884, Rev. 1.8