Transport - PerkinElmer VICTOR Nivo User Manual

7 Stacker Module (Optional)
How to load plates into a magazine
Make sure that all plates are correctly oriented (see A1 marking on the magazine).
There are two ways to fill a magazine:
1. Insert plates through the opening at the top of the magazine one by one.
2. Load an entire plate stack:
l
l
l
How to unload plates from a magazine
There are two ways to empty a magazine:
1. Unload the plates from the opening at the top of the magazine one by one.
2. Unload an entire plate stack:
l
l
l
7.9

Transport

The stacker module with the integrated reader may only be moved carefully on
l
its laboratory bench or table.
Do not lift the stacker module at the front, but only at the side at the marked
l
position to avoid damage to the control panel.
Do not attempt to carry or otherwise transport the system. This may result in the
l
position of the reader being misaligned and the stacker having to be readjusted.
This can only be done by PerkinElmer Service.
54
Stack the sample plates onto the provided magazine support plate (see
previous image).
Open the bottom locking mechanism (see previous image) and lower the
magazine over the plate stack.
When the magazine is on the level of the table, close the locking
mechanism. The magazine support plate should be left on the table and the
plates are loaded into the magazine.
Place the magazine on the lab bench.
Open the bottom locking mechanism of the magazine and hold it in this
position. The plate stack is released and placed on the bench.
Carefully lift the magazine away upwards.
VICTOR Nivo – User Manual