9. Adapter (¼ NPT male connector to 6 mm O.D. push-in fitting, item 4 on
page 39)
10. Pressure gauge for N
Tubing
1. TUBE A (x4) – Rigid tubes, 3 m long, 6 mm O.D. each
Use TUBE A to connect the input ports of nitrogen and carbon dioxide pressure
gauges to the corresponding tanks and to connect the output ports of nitrogen
and carbon dioxide pressure gauges to the corresponding input ports (CO
N
) on the rear panel of the gas controller.
2
2. TUBE AA (x1), 3 m long, red labeled
Use TUBE AA to connect the "Gas Output" of the gas controller to the lower
connector of the VICTOR Nivo reader (use L-shape tubing adapter, see item 5).
3. TUBE AB (x1), 2 m long, blue labeled with PTFE filter
Use TUBE AB to connect the "Gas sensors Input" (blue marked input) to the
upper connector of the VICTOR Nivo reader (use L-shape tubing adapter, see
item 5).
4. Adapter (x2), ¼ NPT male connector to 6 mm O.D. push-in fitting
Connect them to the threaded female connector on the pressure gauges of the
CO
2
VICTOR Nivo – User Manual
+ regulator + assembly stirrup
2
or N
tanks to connect TUBE A to the tank.
2
6 Gas Control (Optional)
and
2
39