Cleaning and
Replacing the
Wiper
DOC-34014 Rev. C
A rubber wiper removes excess material from the print heads after the
purge sequence. This is done automatically before each print job, and
performed manually during maintenance tasks. You should clean the
wiper and surrounding area daily. If the wiper is damaged or worn, replace
it.
To inspect and clean the wiper:
1. Prepare—
•
isopropanol (IPA—isopropyl alcohol) or ethanol (ethyl alcohol)
•
disposable cleaning gloves
•
the supplied cleaning cloth or equivalent
•
a spare wiper
•
an M2.5 hex (Allen
2. Start the Wiper Cleaning wizard from the Options menu.
Figure 6-28: Starting the Wiper Cleaning wizard
3. In the opening wizard screen, click
®
) key
.
Next
Objet24 User Guide
6–23