Setting Up Your System Using Gml Commander; Before You Begin - AB Quality Allen-Bradley 1394 User Manual

Setting Up Your System Using GML
Commander
Commissioning 1394 GMC and GMC Turbo Systems
7.
If the system module LED:
Flashes green
Flashes red and green, flashes
red, or remains solid red
Does not illuminate
8. Apply 24V DC to the system enable (TB1-1, -2 or TB2-1, -2 on
the input wiring board) to enable the system module. The system
module's Status LED should be solid green.
When you apply power to the motion controller, the hardware and
software are initialized. Refer to the GML Commander Reference
Manual (publication GMLC-5.2) or GML 3.x User Manual
(publication 999-104) for a listing of the initialized values.
This section provides the information you need to setup and tune your
1394 GMC and GMC Turbo system using GML Commander.

Before You Begin

Before you begin the setup procedure be sure to have the following:
• A computer running Windows 95 and GML Commander
Note: 1394C-SJTxx-L system modules require GML
Commander 4.03 or later.
• A nine-pin serial cable to connect the computer to the 1394 serial
port
• GML Commander Reference Manual (publication GMLC-5.2)
• A voltmeter
• A standard screwdriver
Then:
The control and bus power are
active, but the modules are not
enabled.
Go to step 8.
You may have a wiring
problem. Go to the
Troubleshooting chapter.
Publication 1394-5.0 — May 2000
6-3