Procedure 7. Installing The G2615A Bar Code Reader - Agilent Technologies agilent 7683B Installation, Operation And Maintenance Manual

Procedure 7. Installing the G2615A Bar Code Reader

1 Locate the recess in the bottom front of the tray. The BCR must be located
Mounting screw holes
Spacer, mounts here
Figure 23
2 Locate the mounting screw holes. Some G2614A trays have two or three
3 If the spacer is needed, align the holes in the spacer with the mounting
Installation, Operation, and Maintenance
Part 1, Installation
at this location. See Figure
The BCR spacer and mounting location
holes that are flush with the bottom of the recess. Those trays require the
spacer. Newer G2614A trays have raised areas around three mounting holes
and do not need the spacer. The G2916A tray when upgraded for use with a
6890 GC requires a spacer.
The tray shown in Figure 23
use of the spacer to mount the BCR.
holes in the bottom of the tray. Place the BCR mounting bracket under the
spacer, insert the two long screws and tighten them firmly. See
If the spacer is not needed, place the BCR mounting bracket under the
mounting holes in the bottom of the tray. Insert the three short screws and
tighten them firmly. See
23.
is the two hole version. This style tray requires
Figure 24.
2
Installation
Figure 24.
53