Chapter 23 Static Route; Configuring Static Route; Figure 70 Static Routing; Table 56 Static Routing - ZyXEL Communications VDSL SWITCH VES-1616F-3X User Manual

C
H A P T E R
This chapter shows you how to configure static routes.

23.1 Configuring Static Route

Static routes tell the switch how to forward IP traffic when you configure the TCP/IP
parameters manually.
Click Routing Protocol > Static Routing in the navigation panel to display the screen as
shown.

Figure 70 Static Routing

The following table describes the related labels you use to create a static route.

Table 56 Static Routing

LABEL
Active
Name
Destination IP
Address
IP Subnet
Mask
Gateway IP
Address
VES-1616F-3x Series User's Guide
DESCRIPTION
This field allows you to activate/deactivate this static route.
Enter a descriptive name for this route. This is for identification purpose only.
This parameter specifies the IP network address of the final destination. Routing is
always based on network number. If you need to specify a route to a single host, use
a subnet mask of 255.255.255.255 in the subnet mask field to force the network
number to be identical to the host ID.
Enter the subnet mask for this destination.
Enter the IP address of the gateway. The gateway is an immediate neighbor of your
switch that will forward the packet to the destination. The gateway must be a router
on the same segment as your switch.
23
Static Route
163