• Remove the remote host with IP address 172.165.1.9 and with an SSH-RSA encryption
key from the list of known hosts.
sysname(config)# no ssh key rsa1
sysname(config)# no ssh known-hosts 172.165.1.8
sysname(config)# no ssh known-hosts 172.165.1.9 ssh-rsa
33.9 interface Commands
These are some commonly used commands that belong to the
commands.
33.9.1 interface port-channel
Syntax:
interface port-channel <port-list>
Use this command to enable the specified ports for configuration. Type multiple ports or port
ranges separated by a comma. Ranges of port numbers are typed separated by a dash.
The following example shows you how to access the interface command mode to configure
ports 1, 3, 4 and 5.
• Enter the configuration mode.
• Enable ports one, three, four and five for configuration.
• Begin configuring for those ports.
sysname# config
sysname(config)# interface port-channel 1,3-5
sysname(config-interface)#
33.9.2 bpdu-control
Syntax:
bpdu-control <peer|tunnel|discard|network>
where
<peer|tunnel|discard|network
>
VES-1616F-3x Series User's Guide
Chapter 33 Command Examples
interface
=
Type
to process any BPDUs received
peer
on these ports.
Type
to forward BPDUs received
tunnel
on these ports.
Type
to drop any BPDUs received
discard
on these ports.
Type
to process and forward
network
BPDUs with a VLAN tag and to process
untagged BPDUs.
group of
253