Account Privilege Levels; Command Modes; Table 78 Command Interpreter Mode Summary - ZyXEL Communications VDSL SWITCH VES-1616F-3X User Manual

32.7 Account Privilege Levels

You can use a command whose privilege level is equal to or less than that of your login
account. For example, if your login account has a privilege level of 12, you can use all
commands with privilege levels from 0 to 12. 0-privileged commands are available to all login
accounts.

32.8 Command Modes

There are three command modes: User, Enable and Configure. The modes (and commands)
available to you depend on what level of privilege your account has. Use the
command in Configure mode to set up accounts and privilege levels.
username
When you first log into the command interpreter with a read-only account (having a privilege
of 0 to 12), the initial mode is User mode. The User mode commands are a subset of the
Enable mode commands. The User mode command prompt ends with an angle bracket (>).
To enter Enable (or privileged) mode using a read-only account, type
administrator password when prompted (the default is 1234). When you enter Enable mode,
the command prompt changes to the pound sign (
an administrator you automatically enter Enable mode.
The following table describes command interpreter modes and how to access them..

Table 78 Command Interpreter Mode Summary

.
MODE DESCRIPTION
User Commands available in this mode are
a subset of enable mode. You can
perform basic tests and display
general system information.
Enable Commands available in this mode
allow you to save configuration
settings, reset configuration settings
as well as display further system
information. This mode also contains
the configure
takes you to config mode.
Config Commands available in this mode
allow you to configure settings that
affect the switch globally.
Command modes that follow are sub-modes of the config mode and can only be accessed from within the config
mode.
VES-1616F-3x Series User's Guide
HOW TO LOGIN/
ACCESS
Default login level for a
read-only account.
Default login level for
the administrator or
accounts with a
privilege of 13 or 14.
Read-only accounts
command which
(with a privilege of 0 -
12) need to type the
enable
and enter the Enable
mode password.
Type
configure
Enable mode.
Chapter 32 Introducing the Commands
enable
). If you log into the command interpreter as
#
PROMPT
sysname>
The first part of the prompt is
the system name. In the CLI
examples in this User's
Guide, the system name is
always "sysname".
sysname#
command
config or
sysname(config)#
in
logins
and enter the
215