Vlan Commands; Table 86 Vlan Commands - ZyXEL Communications VDSL SWITCH VES-1616F-3X User Manual

Chapter 32 Introducing the Commands
Table 85 vdsl-profile Commands (continued)
COMMAND
rateratio
snr
targetslowburst

32.11.8 vlan Commands

The following table lists the

Table 86 vlan Commands

COMMAND
vlan <1-4094>
exit
fixed <port-
list>
forbidden
<port-list>
help
inactive
ip address
240
us <1|2>
ds <0..100>
us <0..100>
dsmax <0..127>
dsmin <0..127>
dstarget
<0..127>
usmax <0..127>
usmin <0..127>
ustarget
<0..127>
ds <0..1275>
us <0..1275>
commands in configuration mode.
vlan
DESCRIPTION
Creates a new VLAN group.
Leaves the VLAN configuration mode.
Specifies the port(s) to be a permanent
member of this VLAN group.
Specifies the port(s) you want to prohibit from
joining this VLAN group.
Displays a list of available VLAN commands.
Disables the specified VLAN.
Sets the IP address and subnet mask of the
<ip-address>
switch in the specified VLAN for packet
<mask>
loopback test.
DESCRIPTION
Sets a rate adaptive mode for the
upstream traffic
1: Manual
2: AdaptAtInit
Specify the downstream data rate
allocated for the fast and slow
channels.
0: slow channel
100: fast channel
Specify the upstream data rate
allocated for the fast and slow
channels.
0: slow channel
100: fast channel
Sets the maximum downstream
SNR (Signal to Noise Ratio).
Sets the minimum downstream
SNR (Signal to Noise Ratio).
Sets the target downstream SNR
(Signal to Noise Ratio).
Sets the maximum upstream
SNR (Signal to Noise Ratio).
Sets the minimum upstream SNR
(Signal to Noise Ratio).
Sets the target upstream SNR
(Signal to Noise Ratio).
Sets the target burst rate for the
downstream slow channel.
Sets the target burst rate for the
upstream slow channel.
VES-1616F-3x Series User's Guide
P
13
13
13
13
13
13
13
13
13
13
13
P
13
13
13
13
13
13
13