Configure A Static Vlan; Figure 31 Vlan > Static Vlan; Table 19 Vlan > Static Vlan - ZyXEL Communications VDSL SWITCH VES-1616F-3X User Manual

7.5.2 Configure a Static VLAN

To configure a static VLAN, click Static VLAN in the VLAN Status screen to display the
screen as shown next.
Use a static VLAN to decide whether an incoming frame on a port should be
• sent to a VLAN group as normal depends on its VLAN tag.
• sent to a group whether it has a VLAN tag or not.
• blocked from a VLAN group regardless of its VLAN tag.
You can also tag all outgoing frames (that were previously untagged) from a port with the
specified VID. Refer to
Figure 31 VLAN > Static VLAN
The following table describes the related labels in this screen.
Table 19 VLAN > Static VLAN
LABEL
ACTIVE
Name
VLAN Group ID
Port
Control
Tagging
Add
VES-1616F-3x Series User's Guide
Section 7.1 on page 87
DESCRIPTION
Select this check box to activate the VLAN settings.
Enter a descriptive name for the VLAN group for identification purposes.
Enter the VLAN ID for this static VLAN; the valid range is between 1 and 4094.
The port number identifies the port you are configuring.
Select Normal for the port to dynamically join this VLAN group using GVRP. This is
the default selection.
Select Fixed for the port to be a permanent member of this VLAN group.
Select Forbidden if you want to prohibit the port from joining this VLAN group.
Select TX Tagging if you want the port to tag all outgoing frames (that were
previously untagged) transmitted with this VLAN Group ID.
Click Add to add the settings as a new entry in the summary table below.
for background information.
Chapter 7 VLAN
91