ZyXEL Communications VDSL SWITCH VES-1616F-3X User Manual page 129

Table 40 Classifier (continued)
LABEL
Ethernet Type Select an Ethernet type or select Other and enter the Ethernet type number in
Source
MAC
Address
Port
Destination
MAC Address Select Any to apply the rule to all MAC addresses.
Layer 3
Specify the fields below to configure a layer 3 classifier.
DSCP
IP Protocol
Source
IP
Address/
Address
Prefix
Socket
Number
Destination
IP
Address/
Address
Prefix
Socket
Number
Add
Cancel
Clear
Index
Active
VES-1616F-3x Series User's Guide
DESCRIPTION
hexadecimal value. Refer to
Select All if you don't know.
Select Any to apply the rule to all MAC addresses.
To specify a source, select MAC and type a MAC address in valid MAC address
format (six hexadecimal character pairs).
Select the port to which the rule should be applied. You may choose one port only or
all ports (All Ports).
To specify a destination, select the second choice and type a MAC address in valid
MAC address format (six hexadecimal character pairs).
Select Any to classify traffic from any DSCP or select the second option and specify a
DSCP (DiffServ Code Point) number between 0 and 63 in the field provided.
Select an IP protocol type or select Other and enter the protocol number in decimal
value. Refer to Table 42 on page 130
You may select Establish Only for TCP protocol type. This means that the switch will
pick out the packets that are sent to establish TCP connections.
Enter a source IP address in dotted decimal notation.
Specify the address prefix by entering the number of ones in the subnet mask.
Note: You must select either UDP or TCP in the IP Protocol field
before you configure the socket numbers.
Select Any to apply the rule to all TCP/UDP protocol port numbers or select the
second option and enter a TCP/UDP protocol port number.
Enter a destination IP address in dotted decimal notation.
Specify the address prefix by entering the number of ones in the subnet mask.
Note: You must select either UDP or TCP in the IP Protocol field
before you configure the socket numbers.
Select Any to apply the rule to all TCP/UDP protocol port numbers or select the
second option and enter a TCP/UDP protocol port number.
Click Add to save the changes.
Click Cancel to reset the fields back to your previous configuration.
Click Clear to set the above fields back to the factory defaults.
This field displays the index number of the rule. Click an index number to edit the rule.
This field displays Yes when the rule is activated and No when is it deactivated.
Table 41 on page 130 for information.
for more information.
Chapter 18 Classifier
129