Mvr Commands; Table 83 Mvr Commands - ZyXEL Communications VDSL SWITCH VES-1616F-3X User Manual

Chapter 32 Introducing the Commands
Table 82 interface port-channel Commands (continued)
COMMAND

32.11.5 mvr Commands

The following table lists the

Table 83 mvr Commands

COMMAND
mvr <1-
4094>
8021p-priority <0 - 7>
exit
236
packet-format
<packet-format>
ethernet-type
<ethernet-type>
vlan <vid> priority
<0-7> inactive
pvid <1-4094>
qos priority <0-7>
speed-duplex <auto|10-half|10-
full|100-half|100-
full|1000-full>
test
vlan-stacking priority <0-7>
role <normal |
access | tunnel>
SPVID <1-4094>
vlan-trunking
weight <wt1>
<wt2> ...
<wt8>
commands in configuration mode.
mvr
DESCRIPTION
Disables the protocol based VLAN.
The default PVID is VLAN 1 for all
ports. Sets a PVID in the range 1 to
4094 for the specified interface.
Sets the quality of service priority for
an interface.
Sets the duplex mode ( half
full 10 100
) and speed ( ,
Mbps) of the connection on the
auto
interface. Selecting (auto-
negotiation) makes one port able to
negotiate with a peer automatically to
obtain the connection speed and
duplex mode that both ends support.
Performs an interface loopback test.
Sets the priority of the specified port(s)
in VLAN stacking.
Sets the VLAN stacking port roles of
the specified port(s).
Sets the service provider VID of the
specified port(s).
Enables VLAN Trunking on ports
connected to other switches or routers
(but not ports directly connected to
end users) to allow frames belonging
to unknown VLAN groups to pass
through the switch.
Sets the queuing weight.
DESCRIPTION
Enters the MVR (Multicast VLAN
Registration) configuration mode.
Select a priority level (0-7) with which
the switch replaces the priority in
outgoing IGMP control packets
(belonging to this multicast VLAN).
Exist from the MVR configuration
mode.
VES-1616F-3x Series User's Guide
P
13
13
13
or 13
1000
or
13
13
13
13
13
13
P
13
13
13