Configuring Snmp; Setting Up Login Accounts; Figure 85 Access Control: Snmp; Table 64 Access Control: Snmp - ZyXEL Communications VDSL SWITCH VES-1616F-3X User Manual

Chapter 26 Access Control
Table 63 SNMP Traps (continued)
OBJECT LABEL
newRoot
topologyChange

26.3.3 Configuring SNMP

From the Access Control screen, display the SNMP screen. You can click Access Control to
go back to the Access Control screen.

Figure 85 Access Control: SNMP

The following table describes the labels in this screen.

Table 64 Access Control: SNMP

LABEL
Get Community
Set Community
Trap Community Enter the trap community, which is the password sent with each trap to the SNMP
Trap Destination
Apply
Cancel

26.4 Setting Up Login Accounts

Up to five people (one administrator and four non-administrators) may access the switch via
web configurator at any one time.
• An administrator is someone who can both view and configure switch changes. The
username for the Administrator is always admin. The default administrator password is
1234.
182
OBJECT ID DESCRIPTION
1.3.6.1.2.1.17.0.1 This trap is sent when the STP root switch changes.
1.3.6.1.2.1.17.0.2 This trap is sent when the STP topology changes.
DESCRIPTION
Enter the get community, which is the password for the incoming Get- and GetNext-
requests from the management station.
Enter the set community, which is the password for incoming Set- requests from the
management station.
manager.
Enter the IP addresses of up to four stations to send your SNMP traps to.
Click Apply to save your changes back to the switch.
Click Cancel to begin configuring this screen afresh.
VES-1616F-3x Series User's Guide