32.10 Saving Your Configuration
After you set the switch settings with the configuration commands, use the
command to save the changes permanently.
sysname# write memory
The
write memory
You must save your changes after each CLI session. All unsaved
configuration changes are lost once you restart the switch.
32.10.1 Logging Out
In User or Enable mode, enter the
mode entering
logs you out of the CLI.
logout
32.11 Command Summary
The following sections summarize the commands available in the switch together with a brief
description of each command. Commands listed are in alphabetical order. The P column on
the right indicates the administrator privilege level needed to use the command.
See the related section in the User's Guide for more background information.
32.11.1 User Mode
The following table describes the commands available for User mode.
Table 79
Command Summary: User Mode
COMMAND
enable
exit
help
history
logout
ping
<ip|host-name>
<[in-band|out-of-band|vlan
<vlan-id>] [size <0-1472>]
[-t ]>
help
VES-1616F-3x Series User's Guide
command is not available in User mode.
exit
takes you out of the Config mode and into Enable mode and entering
exit
Chapter 32 Introducing the Commands
or
command to log out of the CLI. In Config
logout
DESCRIPTION
Accesses Enable (or privileged) mode. See
32.11.2 on page
218.
Logs out from the CLI.
Displays help information.
Displays a list of previously command(s) that you have
executed. The switch stores up to 256 commands in
history.
Exits from the CLI.
Sends Ping request to an Ethernet device.
Displays command help information.
write memory
P
Section
0
0
0
0
0
0
0
217