Chapter 6 Basic Setting
VLAN is unidirectional; it only governs outgoing traffic.
See
Chapter 7 on page 87
6.5 Switch Setup Screen
Click Basic Setting and then Switch Setup in the navigation panel to display the screen as
shown. The VLAN setup screens change depending on whether you choose 802.1Q or Port
Based in the VLAN Type field in this screen. Refer to the chapter on VLAN.
Figure 21 Switch Setup
The following table describes the labels in this screen.
Table 11 Switch Setup
LABEL
VLAN Type
Bridge Control
Protocol
Transparency
MAC Address
Learning
Aging Time
68
for information on port-based and IEEE 802.1Q tagged VLANs.
DESCRIPTION
Choose 802.1Q or Port Based. The VLAN Setup screen changes depending on
whether you choose 802.1Q VLAN type or Port Based VLAN type in this screen.
See
Chapter 7 on page 87
for more information.
Select Active to allow the switch to handle bridging control protocols (STP for
example). You also need to define how to treat a BPDU in the Port Setup screen.
MAC address learning reduces outgoing traffic broadcasts. For MAC address
learning to occur on a port, the port must be active.
Enter a time from 10 to 3000 seconds. This is how long all dynamically learned MAC
addresses remain in the MAC address table before they age out (and must be
relearned).
VES-1616F-3x Series User's Guide