Table 12 Ip Setup - ZyXEL Communications VDSL SWITCH VES-1616F-3X User Manual

The following table describes the labels in this screen.

Table 12 IP Setup

LABEL
Domain Name
Server
Default
Management
In-band Management IP Address
DHCP Client
Static IP
Address
IP Address
IP Subnet
Mask
Default
Gateway
VID
Out-of-band Management IP Address
IP Address
IP Subnet Mask
Apply
Cancel
In-band IP Addresses
You can create up to 128 IP addresses, which are used to access and manage the switch from the
ports belonging to the pre-defined VLAN(s). You must configure a VLAN first.
IP Address
IP Subnet Mask
VID
Default Gateway Enter the IP address of the default outgoing gateway in dotted decimal notation.
VES-1616F-3x Series User's Guide
DESCRIPTION
Enter the IP address of the domain name server in dotted decimal notation, for
example 192.168.1.20.
Select which traffic flow (In-Band or Out-of-band) the switch is to use to send
packets with an unknown source or that originated from the switch itself (such as
SNMP traps).
Select Out-of-band to have the switch send the packets to the out-of-band
management port. This means that device(s) connected to the other port(s) do not
receive these packets.
Select In-Band to have the switch send the packets to all ports except the out-of-
band management port. This means that device(s) connected to out-of-band
management port do not receive these packets.
Select this option if you have a DHCP server that can assign the switch an IP
address and subnet mask, a default gateway IP address and a domain name server
IP address.
Select this option if you don't have a DHCP server or if you wish to assign static IP
address information to the switch. You need to fill in the following fields when you
select this option.
Enter the IP address of your switch in dotted decimal notation for example
192.168.1.1.
Enter the IP subnet mask of your switch in dotted decimal notation for example
255.255.255.0.
Enter the IP address of the default outgoing gateway in dotted decimal notation, for
example 192.168.1.254
Enter the VLAN identification number associated with the switch IP address. This is
the VLAN ID of the CPU and is used for management only. The default is "1". All
ports, by default, are fixed members of this "management VLAN" in order to
manage the device from any port. If a port is not a member of this VLAN, then users
on that port cannot access the device. To access the switch make sure the port that
you are connected to is a member of Management VLAN.
Enter the IP address of your switch in dotted decimal notation for example
192.168.0.1.
Enter the IP subnet mask of your switch in dotted decimal notation for example
255.255.255.0.
Click Apply to save the settings.
Click Cancel to reset the fields to your previous configuration.
Enter the IP address for managing the switch by the members of the VLAN
specified in the VID field below.
Enter the IP subnet mask in dotted decimal notation.
Type the VLAN group identification number.
Chapter 6 Basic Setting
71