Link Aggregation Setup; Figure 43 Link Aggregation Control Protocol > Configuration; Table 34 Link Aggregation Control Protocol > Configuration - ZyXEL Communications VDSL SWITCH VES-1616F-3X User Manual

Table 33 Link Aggregation Control Protocol Status (continued)
LABEL
Poll Interval(s)
Stop

14.3 Link Aggregation Setup

Click Configuration in the Link Aggregation Control Protocol Status screen to display the
screen shown next.
See Section 14.1 on page 113
Figure 43 Link Aggregation Control Protocol > Configuration
The following table describes the labels in this screen.
Table 34 Link Aggregation Control Protocol > Configuration
LABEL
Link Aggregation Control Protocol
Active
System
Priority
Group ID
Active
Dynamic
(LACP)
Port
Group
VES-1616F-3x Series User's Guide
DESCRIPTION
The text box displays how often (in seconds) this screen refreshes. You may change
the refresh interval by typing a new number in the text box and then clicking Set
Interval.
Click Stop to halt statistic polling.
for background information.
DESCRIPTION
Select this checkbox to enable Link Aggregation Control Protocol (LACP).
LACP system priority is a number between 1 and 65,355. The switch with the lowest
system priority (and lowest port number if system priority is the same) becomes the
LACP "server". The LACP "server" controls the operation of LACP setup. Enter a
number to set the priority of an active port using Link Aggregate Control Protocol
(LACP). The smaller the number, the higher the priority level.
The field identifies the link aggregation group, that is, one logical link containing
multiple ports
Select this option to activate a trunk group.
Select this check box to enable LACP for a trunk.
This field displays the port number.
Select the trunk group to which a port belongs.
Chapter 14 Link Aggregation
115