ZyXEL Communications Corporation. Published by ZyXEL Communications Corporation. All rights reserved. Disclaimer ZyXEL does not assume any liability arising out of the application or use of any products, or software described herein. Neither does it convey any license under its patent rights nor the patents rights of others.
GS-105A/GS-108A User’s Guide FCC Warning This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a commercial environment.
Page 4
GS-105A/GS-108A User’s Guide ZyXEL. This warranty shall not apply if the product is modified, misused, tampered with, damaged by an act of God, or subjected to abnormal working conditions. Note Repair or replacement, as provided under this warranty, is the exclusive remedy of the purchaser.
Customer Support If you have questions about your ZyXEL product or desire assistance, contact ZyXEL Communications Corporation offices worldwide, in one of the following ways: Contacting Customer Support When you contact your customer support representative, have the following information ready: ♦...
Standalone Workgroup Example Hardware Installation The switch is suitable for an office environment where it can be placed on a desktop. Make sure the switch is clean and dry.
Rear Panel: GS-108A Power Connection Connect one end of the supplied power adaptor to the power port on the rear panel of the switch and the other end to the appropriate power source. The PWR LED turns on. RJ-45 Auto-negotiating Ports The switch comes with 5 or 8 10/100/1000M RJ-45 ports depending on the model of your switch.
Refer to the Product Specifications section for the types of network cable used for the different connection speeds. Front Panel LEDs The LEDs on the front panel indicate the real-time status of the switch. Table 1 Front Panel LED Descriptions COLOR...
Product Specifications Standard Protocol Technology Transfer Rate Connector MAC Address Memory Buffer Network Cable (Up to 100m or 328ft) Backplane Power Supply Power Consumption Operation Temperature Operation Humidity Dimension EMI & Safety ENGLISH IEEE 802.3 10BASE-T Ethernet, IEEE 802.3u 100BASE-TX Fast Ethernet IEEE 802.3ab Gigabit Ethernet IEEE802.3x Flow Control and Back-pressure CSMA/CD...
Hochgeschwindigkeitsnetzwerkanwendungen bietet. Der Switch wurde für SOHO-Anwendungen (kleine Büro- und Heimanwendungen) entwickelt. Selbständige Arbeitsgruppen-Anwendung Der Switch kann als selbständiger Switch eingesetzt werden, an den Computer, Server und Druckserver zur Bildung einer kleinen Arbeitsgruppe direkt angeschlossen werden. Beispiel für selbständige Arbeitsgruppen Hardware-Installation Der Switch eignet sich für Büroumgebungen und kann auf einem...
Page 12
Stromanschluss auf der Rückseite des Switches, das andere Ende mit einer geeigneten Stromquelle. Die PWR-LED leuchtet auf. RJ-45 Auto-negotiating-Ports Der Switch wird mit 5 oder 8 10/100/1000M RJ45-Ports geliefert, je nach Modell Ihres Switchs. Die Auto-negotiation-Funktion ermöglicht dem Switch, die Geschwindigkeit ankommender Übertragungen zu erkennen und sich ohne manuellen Eingriff darauf einzustellen.
Page 13
Blinken DEUTSCH Frontplatten-LED: GS-108A BESCHREIBUNG Der Switch ist eingeschaltet und wird mit Strom versorgt. Der Switch wird nicht mit Strom versorgt. Der Port arbeitet mit 1000 Mbps. Der Port arbeitet mit 100 Mbps. Der Port arbeitet mit 10 Mpbs oder es ist kein Gerät angeschlossen.
Page 14
Produktspezifikationen Standard Protokoll Technologie Transferrate Anschluss MAC-Adresse Speicherpuffer Netzwerkkabel (bis 100 m) Bus-Leiterplatte Stromversorgung Stromverbrauch Betriebstemperatur Betriebsluftfeuchtigkeit 10 % bis 90 % (nicht kondensierend) Abmessungen EMI & Sicherheit DEUTSCH IEEE 802.3 10BASE-T Ethernet, IEEE 802.3u 100BASE-TX Fast Ethernet IEEE 802.3ab Gigabit Ethernet IEEE802.3x Flow Control und Back-pressure CSMA/CD Store-and-Forward switching-Architektur...
Faire connaissance de votre commutateur Prise en main de votre switch Introduction Ce commutateur est un commutateur multi-port qui peut être utilisé pour mettre en place des réseaux commutés à hautes performances. Ce commutateur est un périphérique de stockage et de retransmission qui offre un faible temps de latence pour des réseaux grand vitesse.
Page 16
Ne pas obstruer les orifices de ventilation. Connexion de l'équipement Les ports alimentation et Ethernet sont situés sur le panneau arrière. Panneau arrière : GS-105A Panneau arrière : GS-108A Connexion de l'alimentation Connectez l'une des extrémités de l'adaptateur d'alimentation fourni sur le port alimentation sur le panneau arrière du commutateur et l'autre extrémité...
Page 17
utiliser soit un câble Ethernet intermédiaire ou un câble Ethernet crossover pour la connexion de tous les ports Ethernet. Les ports auto-crossover déterminent automatiquement s'ils doivent fonctionner comme ports crossover ou comme ports intermédiaires, de sorte que les câbles crossover permettent de connecter à la fois les ordinateurs et les interrupteurs/hubs.
Page 18
Spécifications du produit Norme Protocole Technologie Taux de transfert Connecteur Adresse MAC Tampon mémoire Câble réseau (Jusqu'à 100m ou 328 pieds) Plaque arrière Voyant DEL Alimentation électrique Consommation électrique Température de mise en oeuvre Humidité de mise en oeuvre Dimensions EMI &...
Ejemplo de Grupo independiente Instalación de hardware El switch es adecuado para el entorno de una oficina donde puede ser colocado en un escritorio. Paso1 Asegúrese de que el switch está limpio y seco.
Page 20
Conexión de alimentación Conecte un extremo del adaptador de alimentación suministrado al puerto de alimentación en el panel posterior del switch y el otro extremo a la fuente de alimentación apropiada. El LED PWR se encenderá. Puertos RJ-45 autonegociantes El switch viene con 5 u 8 puertos 10/100/1000M RJ-45 según el modelo...
Page 21
Consulte las Especificaciones de producto para conocer los tipos de cable de red utilizados para las diferentes velocidades de conexión. LEDs de Panel Frontal Los LEDs del panel frontal indican el estado del switch en tiempo real. Tabla 1 Descripciones de LED de panel frontal COLOR...
Page 22
Especificaciones de producto Estándar Protocolo Tecnología Velocidad de transferencia Conector Dirección MAC Búfer de memoria Cable de red (Hasta 100m o 328ft) Placa base Fuente de alimentación Consumo de alimentación Temperatura de funcionamiento Humedad de funcionamiento Dimensiones EMI y Seguridad ESPAÑOL IEEE 802.3 10BASE-T Ethernet, IEEE 802.3u 100BASE-TX Fast Ethernet...
Imparare a conoscere il commutatore Introduzione Il commutatore è un commutatore a più porte che può essere utilizzato per costruire reti commutate ad alte prestazioni. Il commutatore è un dispositivo di memorizzazione e ritrasmissione che offre bassa latenza per reti ad alta velocità. Il commutatore è progettato per imprese (domestiche ed i piccoli uffici) SOHO.
Page 24
Collegamento dell’hardware La porta d’alimentazione e le porte Ethernet si trovano sul pannello posteriore. Pannello posteriore: GS-105A Pannello posteriore: GS-108A Collegamento dell’alimentazione Collegare una estremità dell’adattatore di corrente fornito nella porta d’alimentazione sul pannello posteriore del commutatore, e l’altra estremità nella presa di corrente appropriata. Il LED d’alimentazione (PWR) si accende.
Page 25
Le porte auto-permutanti rilevano automaticamente se devono funzionare come porte d’incrocio o porte dirette, quindi i cavi incrociati possono collegare sia i computer sia i commutatori / hub. Fare riferimento alla sezione Specifiche del prodotto per quanto riguarda i tipi di cavi di rete utilizzati per le varie velocità dei collegamenti. LED del pannello frontale I LED sul pannello frontale indicano lo stato in tempo reale del commutatore.
Specifiche del prodotto Standard Protocollo Tecnologia Velocità di trasferimento Connettore Indirizzo MAC Buffer di memoria Cavo di rete (fino a 100m o 328 piedi) Backplane Alimentazione Consumo energetico Temperatura operativa da 0º C a 45º C (da 32º F a 113º F) Umidità...