Mvr Commands; Table 89 Mvr Commands - ZyXEL Communications ZyXEL Dimension ES-3148 User Manual

ES-3148 User's Guide
Table 88 Command Summary: config-vlan Commands (continued)
COMMAND
exit
ip address

34.11.6 mvr Commands

The following table lists the

Table 89 mvr Commands

COMMAND
mvr <1-
4094>
source-port
<port-list>
260
DESCRIPTION
Sets the default in-band interface
ip address
to use a static IP address in this
inband-default
VLAN.
dhcp-bootp
The switch will use the default IP
address of 0.0.0.0 if you do not
configure a static IP address.
Deletes the IP address and subnet
ip address <ip-
mask from this VLAN.
address> <mask>
Deletes the default gateway from
ip address
this VLAN.
default-gateway
Leaves the VLAN configuration
mode.
Sets the dynamic in-band IP
inband-default
address.
dhcp-bootp
Releases the dynamic in-band IP
inband-default
address.
dhcp-bootp
release
Updates the dynamic in-band IP
inband-default
address.
dhcp-bootp
renew
Sets a static in-band IP address
inband-default
and subnet mask.
<ip-address>
<mask>
Sets the management IP address
<ip-address>
and subnet mask of the switch in
<mask>
the specified VLAN.
manageable
<ip-address> Sets the IP address and subnet
mask of the switch in the specified
<mask>
VLAN.
Sets a default gateway IP address
default-gateway
for this VLAN.
<ip-address>
commands in configuration mode.
mvr
DESCRIPTION
Enters the MVR (Multicast VLAN
Registration) configuration mode.
Sets the source port(s).
An MVR source port can send and
receive multicast traffic in a
multicast VLAN.
PRIVILEGE
13
13
13
13
13
13
13
13
13
13
13
PRIVILEGE
13
13
Chapter 34 Introducing Commands