Mvr Commands; Table 77 Command Summary: Mvr Commands - ZyXEL Communications GS-3012F User Manual

GS-3012/GS-3012F User's Guide
Table 76 Command Summary: Interface (continued)
COMMAND
pvid
qos priority
speed-duplex
spq
test
vlan-trunking
wrr

30.9.6 mvr Commands

The following table lists the mvr commands in configuration mode.

Table 77 Command Summary: mvr Commands

COMMAND
mvr <1-4094>
8021p-priority <0 -
7>
exit
group <name-str>
start-address <ip>
end-address <ip>
inactive
mode
<dynamic|compatibl
e>
191
<1-4094>
<0 .. 7>
<auto|10-half|10-
full|100-half|100-
full|1000-full>
wt1> <wt2> ... <wt8>
DESCRIPTION
The default PVID is VLAN 1 for all ports.
Sets a PVID in the range 1 to 4094 for the
specified interface.
Sets the quality of service priority for an
interface.
Sets the duplex mode (half, full) and
speed (10/100/1000 Mbps) of the
connection on the interface. Selecting
auto (auto-negotiation) makes one port
able to negotiate with a peer automatically
to obtain the connection speed and duplex
mode that both ends support.
Sets the interface to use Strict Priority
Queuing.
Performs an interface loopback test.
Enables VLAN Trunking on ports
connected to other switches or routers
(but not ports directly connected to end
users) to allow frames belonging to
unknown VLAN groups to pass through
the switch.
Sets the interface to use Weighted Round
Robin queuing (WRR).
Sets the WRR weight. A weight value of
one to eight is given to each variable from
wt1 to wt8.
DESCRIPTION
Enters the MVR (Multicast VLAN Registration)
configuration mode.
Select a priority level (0-7) with which the switch
replaces the priority in outgoing IGMP control
packets (belonging to this multicast VLAN).
Exist from the MVR configuration mode.
Sets the multicast group range for the MVR.
Disables MVR settings.
Sets the MVR mode (dynamic or compatible).
Chapter 30 Introducing the Commands