Enabling Loopback Testing On An Ethernet Interface; Configuring Generic Flow Control On An Ethernet Interface - H3C S7500X Series Interface Configuration Manual

Step
3. Set the FEC mode of the
Ethernet interface.

Enabling loopback testing on an Ethernet interface

Perform this task to determine whether an Ethernet link works correctly.
Loopback testing includes the following types:
•
Internal loopback testing—Tests the device where the Ethernet interface resides. The
Ethernet interface sends outgoing packets back to the local device. If the device fails to receive
the packets, the device fails.
•
External loopback testing—Tests the inter-device link. The Ethernet interface sends incoming
packets back to the remote device. If the remote device fails to receive the packets, the
inter-device link fails.
Configuration restrictions and guidelines
•
After you enable this feature on an Ethernet interface, the interface does not forward data
traffic.
•
The shutdown, port up-mode, and loopback commands are mutually exclusive.
•
Enabling loopback testing on an interface will invalidate the voice VLAN, MAC learning limit,
MAC address learning, 802.1X, and MAC authentication configurations on the interface. To
make these features take effect on the interface, disable loopback testing and configure the
features again.
•
This feature is used only for debugging and troubleshooting.
Configuration procedure
To enable loopback testing on an Ethernet interface:
Step
1. Enter system view.
2. Enter Ethernet interface
view.
3. Enable loopback testing.

Configuring generic flow control on an Ethernet interface

IMPORTANT:
• This feature is not supported on interfaces that operate in half duplex mode.
• Enabling or disabling this feature on an interface will cause the interface to go down and then
come up.
Command
port fec mode { auto | base-r |
none | rs-fec }
Command
system-view
interface interface-type
interface-number
loopback { external | internal }
12
Remarks
The default is auto for 100-GE
interfaces.
100-GE interfaces do not support
the base-r keyword.
Remarks
N/A
N/A
By default, loopback testing is
disabled on an Ethernet interface.
The external keyword is not
supported in the current software
version.