Panel Cutting Dimensions; Mounting Position - Mitsubishi Electric GT11 User Manual

6.2 Panel Cutting Dimensions

Make holes in the panel according to the dimensions list below.
Also, ensure 10mm of space in upper and lower parts of the panel for mounting fixtures.
Horizontal format (If the vertical format is selected, the dimension must be rotated 90 degrees.)
+2
153 (6.03"
-0

6.3 Mounting Position

When mounting the GOT, the following clearances must be maintained from other structures and devices.
The below diagram represents a horizontal installation. (The same clearances must be maintained when
rotating the GOT 90 degrees clockwise for a vertical installation.)
Installation Environment
In the presence of radiated-noise or
heat-generating equipment nearby
In the absence of radiated-noise or
heat-generating equipment nearby
*1 Vertical Format....50 mm (1.97") or more
*2 Vertical Format....80 mm (3.14") or more
C
+0.08"
)
-0
10 (0.4")
or more
10 (0.4")
or more
Unit: mm (inch)
A,D
50 mm (1.97")
or more
20 mm (0.79")
or more
D
Type
GT1155-QTBD
GT1155-QSBD
GT1150-QLBD
GT1155-QTBDQ
GT1155-QSBDQ
GT1150-QLBDQ
GT1155-QTBDA
GT1155-QSBDA
GT1150-QLBDA
B
When the CF
card is not used
80 mm (3.14") 50 mm (1.97")
*1 *2
or more or more
20 mm (0.79") 20 mm (0.79")
or more or more
E
Panel thickness: 2 to 4mm
(0.08 to 0.16inch)
6.2 Panel Cutting Dimensions
Panel thickness [mm] (inch)
Within 2 (0.08") to 4 (0.16")
C
E
When the CF
card is used
100 mm (3.93")
or more
100 mm (3.93")
or more
20 mm (0.79")
or more
6 - 4
1
2
3
4
5
6
7
8