Table of Contents
Advertisement
6.2 Panel Cutting Dimension
Make holes in the panel according to the dimensions list below.
Also, ensure 10mm of space in upper and lower parts of the panel for mounting fixtures.
• Horizontal format (If the vertical format is selected, the dimension must be rotated 90 degrees.)
6.3 Mounting Position
When mounting the GOT, the following clearances must be maintained from other structures and devices.
• The below diagram represents a horizontal installation. (The same clearances must be maintained when rotating the
GOT 90 degrees clockwise for a vertical installation.)
Installation Environment
In the presence of radiated-noise or heat-generating equipment nearby
In the absence of radiated-noise or heat-generating equipment nearby
*1
Vertical Format....50 mm (1.97") or more
*2
Vertical Format....80 mm (3.14") or more
C
6 - 2
6. INSTALLATION
6.2 Panel Cutting Dimension
+2
+0.08 "
153
(6.03"
)
-0
-0
D
10 (0.4")
or more
Within 2 (0.08") to 4 (0.16")
10 (0.4")
or more
Unit: mm (inch)
A, D
B
50mm or more
80mm or more
20mm or more
20mm or more
Panel thickness: 2 to 4mm
(0.08 to 0.16inch)
C
E
*1
*2
100mm or more
50mm or more
20mm or more
20mm or more
E
Advertisement
Table of Contents
