Display Contents Of Communication Detail Settings - Mitsubishi Electric GT11 User Manual

Communication parameter setting using drawing software
(1) Select [System Environment]

10.2.3 Display contents of communication detail settings

Display items or setting items of communication detail settings depend on the type of communication driver
installed in the GOT.
For the setting contents of each driver, refer to the following.
GT Designer2 Version
GT Designer3 Version1 Screen Design Manual (Fundamentals)
This section describes the items that can be set using only the utility screen.
(1) Detail setting of Host (Modem)
On the communication detail setting screen of the Host (Modem), communication settings between
GOT and modem, and model operation can be executed.
enter the communication parameters for each communication driver.
When using GT Designer3, execute the settings at [Controller Setting...] of
[Common].
To change the communication parameter setting after downloading project data,
change the setting at [Communication Detail Setting] (described in this section).
For [Communication Settings] using drawing software, refer to the following
manual.
GT Designer 2 Version
GT Designer 3 Version1 Screen Design Manual (Fundamentals)
Screen Design Manual
10.2.3 Display contents of communication detail settings
[Communication Settings] from GT Designer2 to
Screen Design Manual
10.2 Communication Detail Settings
9
10
11
12
13
14
15
16
10 - 9