Display - Mitsubishi Electric GT11 User Manual

14.3.4 Display

Outline until the start
1
This subsection describes an outline until the system monitor screen is displayed after List editor for
MELSEC-A (Option OS) is installed in the GOT.
Starting from the utility
Display the utility.
After the utility is displayed, touch [Debug & self check]
[Debug] [MELSEC-A List editor] from the Main Menu.
For how to display the utility, refer to the user's manual
of the GOT to be used.
When no keyword is entered
in the target PLC
(Initial information displayed in the display area)
14 - 52
14.3 MELSEC-A List Editor
14.3.4 Display
Turn on the power to the GOT.
Read the PLC and display
the sequence program.
*** MODE SELECTION ***
(READ) (INS) (PARAM)
PRESS MODE KEY
(1) How to display the utility
For how to display the utility, refer to the following.
Section 9.3 Utility Display
(2) If the project data has not been downloaded
The A list editor can be started from the utility even if the project data has not been
downloaded to the GOT.
Start
Touch the special function switch.
Refer to the following manual for how to set the special
function switch.
GT Designer2 Version
Manual
GT Designer3 Version1 Screen Design
Manual (Functions)
When a keyword is entered
in the target PLC
Enter the keyword.
Subsection 14.3.5 Operation of keyword input
Starting from the special function
switch (MELSEC-A List editor)
set in the project data
Screen Design