Action If An Incorrect Key Is Input - Mitsubishi Electric GT11 User Manual

(5) For extension timer/extension counter of AnA and AnUCPU
When the extension timer (T256 to T2047) and the extension counter (C256 to C1023) are input as
the first device of the command, input the first device and the device number.
(Ex) When OUT T256 D500 is input
W 9 9
1 0 0
1 0 1
1 0 2
W 1 0 1
1 0 2
1 0 3
1 0 4

14.3.11 Action if an incorrect key is input

If an incorrect key is input, cancel the input contents.
Operation
1
(1) Before touching the
Before touching the
(2) After touching the
Write the command again. (
Commands finalized by writing and inserting operations are revised (overwritten) with the program
writing.
Remark
14 - 64
14.3 MELSEC-A List Editor
14.3.11 Action if an incorrect key is input
M 1 0
0 U T
L D
N 0 P
N 0 P
OUT T 2 5 6
T 2 5 6
0 U T
D 5 0 0
N 0 P
N 0 P
When the extension timer and the extension counter are used, be sure to set the
257 points or more and the setting value device (D, W, R) on the parameter for
both the timer and the counter.
key (before reading/writing the input contents)
GO
key, touch the
GO
key (after reading/writing the input contents)
GO
When the
CLEAR
To continue the operation, carry on the key input.
GO
The device (D500) for the T256 setting value
on the parameter is automatically displayed.
key.
CLEAR
Subsection 14.4.9 Writing commands)
key is input in the parameter mode, the GOT stops the process.