Sony MVS-8000SF User Manual page 1126

• As for "Aux ? O'ride Src ??," when "Rising Edge" is selected, on a rising
• If "SWR Format" or "System Format" is selected for "Action" when the
Carrying out level settings
To set the low level and high level, first set the trigger type to "Level," then use
the following procedure.
1
2
3
1126
GPI Input Setting (GPI Input Assign Menu)
off and the power may go off before the action is completed. This may
corrupt the setup settings. It is therefore recommended to use Level Enable
to avoid such a situation.
edge the set AUX bus primary input is used. On a falling edge, the original
state of the cross-point is restored. If the GPI trigger is applied repeatedly at
short intervals (0.5 second or less), the cross-point switching may not be
carried out correctly. In this case, apply the GPI trigger again.
format converter is used on the MVS-8000G, you can set the conversion
formats of the format converter for "FC Input 1-8" and "FC Input 9-16."
In place of the conversion format, you can also select "Frame Delay," but in
this case "FC Input1-8" is disabled.
In the DCU >GPI Input Assign menu, select the action to be set, and press
[H/L Set].
The H/L Set menu appears.
Using any of the following methods, select the settings.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
Knob Parameter
1 No
To apply the selection made in step 2 when the input is the GPI high level,
press [H Set]. To apply the selection made in step 2 when the input is low,
press [L Set].
This confirms the setting, which appears in the status area.
Adjustment
Signal format/screen aspect ratio
selection
Setting values
1 and upwards