Table of Contents
Advertisement
Installation, Operations, Service & Maintenance
ProCore Edge
Uploading Software:
When the upload begins, you will see
the Upload Progress screen as shown
to the right.
The list of selected devices is shown
with an individual status indicator and
progress bar.
The time left and percent completion
of the entire batch job is shown at the
bottom of the screen. This screen is
designed to run without interruption so
you may leave your device unattended
while the upload is in progress.
When all uploads have completed, you
may select Stop to return to the Device
Select screen again.
If any of the uploads fail, the app will
continue to cycle through them to retry
indefinitely until you select Stop and
confirm you wish to cancel the upload.
Fig. 76 – Uploading Software
If you select Stop during the upload, all
pending uploads are canceled, but the
current load in progress cannot be interrupted or the equipment will be rendered
inoperable until the next upload is performed.
After the current load completes – whether successful or not – the upload will stop.
At this point, selecting Stop again takes you back to the Device Select screen.
If an upload is interrupted by the app closing, the mobile device going out of
range, or the Webasto Equipment powering OFF, you can re-try the upload again
when conditions are restored. The Webasto Equipment will still be listening for
the app.
Part Number 5911110 A02
Page 98 of 112
Webasto Charging Systems, Inc.
Advertisement
Table of Contents
