Table of Contents
Advertisement
ProCore Edge
Initial Software Setup
Purpose:
The purpose of this procedure is to describe how main application software is
installed onto the ProCore Edge charger system board, either by the manufacturer
or in the field.
NOTE: This procedure describes the method of loading the firmware using a
PC-connected via USB port. Firmware can also be loaded using a smart phone
connected via Bluetooth. For the smart phone procedure see PLMS part no.
25129-11 for iOS devices.
Scope:
This procedure relies on ProCore Edge Bootloader SW version 1.027 or later.
Components and Descriptions:
Component
ProCore Edge Charger
LCD Screen
System Board
USB
PilotTerm
AVB File
Webasto Charging Systems, Inc.
Description
Industrial opportunity charger
The graphical interface located on the front of the
ProCore Edge charger
The PCB located inside the charger which controls
the LCD screen, stack lights, and power output
Universal Serial Bus – a USB connector is located
on the side the unit
Windows
application that communicates with the
TM
charger via the USB port
Loadable binary application file – this refers to the
-11 main application loaded using PilotTerm, which
has an extension of .avb
Page 61 of 112
Installation, Operations, Service & Maintenance
Part Number 5911110 A02
Advertisement
Table of Contents
