Table of Contents
Advertisement
ProCore Edge
Replacing the Output Cable
DC output power cable connection
1. Unplug any vehicles connected to the charger.
NOTE
Always press the STOP button on the ProCore Edge battery display before
disconnecting SB cables from a battery. Pressing the STOP button will prevent
the possibility of electrical arcing.
2. Turn OFF the AC power at the breaker and lock it out.
3. Wait five minutes for the capacitor voltages to bleed down.
4. Remove the TORX TX25 screws from the DC output power cable panel
located at the bottom left of the charger, and pull the panel up and away
from the charger cabinet.
Webasto Charging Systems, Inc.
Installation, Operations, Service & Maintenance
Page 81 of 112
Fig. 53 – Torx TX25
Screws Securing
the DC Output Power
Cable Panel
Part Number 5911110 A02
Advertisement
Table of Contents
