Table of Contents
Advertisement
ProCore Edge
Replacing a Module
1. Unplug any vehicles connected to the charger.
NOTE
Always press the STOP button on the ProCore Edge battery display before
disconnecting SB cables from a battery. Pressing the STOP button will prevent
the possibility of electrical arcing.
2. Turn OFF the AC power at the breaker and lock it out:
a.
Remove the AC input by performing a LOTO to safely remove AC
input from service.
b.
Disconnect the battery charger from the input power and battery
connections before servicing the unit. Lockout/tagout the input
power according to OSHA 29 CFR 1910.147.
c.
Rest the unit – allow 30 minutes to discharge prior to servicing,
then test the components to ensure it is properly discharged.
DANGER
IMPORTANT
Make sure the charger is completely POWERED OFF and that NO BATTERY
IS CONNECTED before opening the charger door and replacing a power module.
Power module replacement should only be performed by qualified (service) personnel.
3. Open the charger door.
To unlock the door and open it,
use a flathead screwdriver to
turn the latch on the side of the
charger.
Webasto Charging Systems, Inc.
Installation, Operations, Service & Maintenance
Fig. 38 – Latch on the Side of the Charger
Page 69 of 112
Part Number 5911110 A02
Advertisement
Table of Contents
