Table of Contents
Advertisement
Installation, Operations, Service & Maintenance
9. Select the Terminal tab, then enter ver in Send Data and select Send.
The terminal window will display the following information (the version and
CRC may vary):
Confirm the firmware version matches the one that was just loaded, and
confirm the Run Mode is Release (for production unit).
10. The loaded application should begin after the firmware load is complete.
You may unplug the USB cable after this point.
Part Number 5911110 A02
Fig. 37 – Terminal Tab
Page 64 of 112
ProCore Edge
Webasto Charging Systems, Inc.
Advertisement
Table of Contents
